Institute of Architecture

IfA FabLab

Laser cutting/3D printing/Electronics

Sara Aghajani M.Sc.
Room: A-204a (2. Level)

Tel: N.N

Mail: aghajani(at)


Opening Hours:

Mo-Do   12.00-13.00 und 13.30-17.45

Fr              9.00-14.15



Samuel Kleinschmidt



Dear students,

An introductory course is required to use the FabLab. We recommend you to take the Fab Lab introduction course as early as possible. You can now register for the introductory courses on ISIS. The subjects that are covered in this course are the workplace safety and regulations. You will also learn about the fundamentals of operating the laser cutters and the 3D printers. Please keep in mind that all the students are responsible for producing their own models in the Fab Lab. Therefore, the employees of the lab are not able to prepare your models for you. However, we would like to provide you with enough guidance so that you will be able to use the machines in a timely manner throughout the semester.

When attending the course, it would be very helpful to bring your laptops with Craftware Pro software installed on them. You can find the software here:

During the introduction courses, the lab is only available for the course attendances.

We are looking forward to seeing you.


Your Fab Lab Team